Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 7
IMPORTANT: Do not tighten nuts completely, as
Latches must slide up and down freely.
7. Remove Chute Deflector from the mower deck by
removing (2) 3/8-16 nuts from the chute bracket
and save for future usage.
DANGER:
Do not operate mower
without the grass collector installed. If the
grass collector kit is removed the chute
deflector must be installed.
8. Remove chute baffle from the mower deck. This
part will be reinstalled in the next step with the new
baffle and hardware provided. See Figure 8.
Washer
Chute Baffle
Bolt
Figure 8
ASSEMBLY AND OPERATION
Pan Head
Screw
Right Latch
Nut
Nut
5
9. Attach Chute Baffle [S] and chute baffle previously
removed in step 8 to the inside of the mower deck
using (1) 5/16-18 x 1.00 bolt [T], (1) 5/16 Flat
Washer, and (1) 5/16-18 Nylock nut.
See Figure 9 below.
Bolt
Washer
Chute Baffle
Figure 9
10. Using (2) 3/8-16 x 1.25 bolts [O] and (2) 3/8-16
Nylock nuts [R], attach backing plate [F] to the unit
as shown below in Figure 10.
Figure 10
Nut
Chute Baffle
Chute
Mounting
Bracket
Nut
Bolt
Publicidad
