Publicidad
Idiomas disponibles
Idiomas disponibles
|
825P-850P DIGITAL PULSE OUTPUT METERS
APPENDIX C - Fluid Calibration (Other Than Water)
CAUTION
DO NOT perform this calibration unless you fully understand how CAL factors work.
CAUTION
Calibrating with a fluid other than water voids
Table #1 (calibration table page 6).
After calibration, set the meter to CAL 4, and
use the meter on CAL 4 (unless you input a
different number during step 9 below).
You will need a container of known volume, at least 5 gallons or
larger. Do not exceed a 60 gallon container.
1. Press the
2
&
4
buttons at the same time and hold for 3
seconds.
The display will read the version of the software loaded in
the meter (example: "r1.02").
2. Press button
3
to enter calibration mode.
The unit of measure will be displayed.
3. Press the
button to change unit of measure, if required.
This is ONLY necessary if calibrating a different unit
of measure.
3
4. Press button
.
The display will read "FILL".
sotera.com
INSTALLATION AND OPERATION MANUAL
5. Now dispense fluid into your container. "FILL" will flash on
the display. For best results, dispense fluid at the same flow
rate that will be used in actual use.
6. After dispensing, press the
The left digit of the display will blink.
4
7. Press the
button to increment the digit to the amount of
fluid dispensed (example: 05.00).
Press the
button to move to the right.
If you make a mistake, press button
left- most digit.
8. After number is loaded, press
9. Display now shows
This is the default for water. Check Table 1 for your fluid.
3
Press
to change the Cal #. Press
again Show "r1.02".
NOTE: IF YOU ACCEPT CAL 4, USE THE METER ON CAL 4 WHEN
DISPENSING THIS FLUID.
NOTE: If the value entered is out of an acceptable range, the
display will read "Err0" and the meter will revert to the previous
settings. See Troubleshooting Guide for more information.
10. Press
2
to get back to the normal operating mode.
button.
2
to start back at the
button again to accept.
.
to accept. Display will
15
Publicidad
