Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Handle assembly
8" Auger bit
Locking pin with Pin clip
5mm hex key
10mm wrench
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
OPERATION
WARNING:
Contact your local utility for underground service
marking before using this product to avoid contact
with underground utilities.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
packs from the product when assembling parts.
ASSEMBLING THE HANDLES
See Figures 2 - 3.
With the RIDGID logo facing away from you, insert the
tubes of the right and left handle assemblies into the
power head base plate tubing.
Each handle will align with two holes on each side and
cannot be installed unless they are properly aligned.
After all hardware is installed, tighten first by hand, then
tighten securely with the included tools (hex key and flat
wrench).
Connect the right side handle to the exposed cable lead-
ing to the motor controller in the power head.
Secure the two wire harness connectors of the wire as-
sembly by screwing the terminals together until thumb
tight with the integrated nut on the power head connector.
ASSEMBLING THE HOLE AUGER
See Figures 4 - 5.
Stand the auger bit upright with tip pointing down.
Remove the locking pin with pin clip from the auger.
Install the drive shaft onto the power head.
Align the holes on the auger and drive shaft.
Insert the locking pin and secure with the pin clip.
WARNING:
To reduce the risk of electrocution, never use the
auger near any buried electrical power cables.
Contact with or use near buried electrical power
cables may cause serious injury or electric shock
resulting in death.
7 — English
Publicidad
