Daewoo DRP-123 Manual De Instrucciones página 5

Radio portátil am/fm - ca/cc
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LOCATION OF CONTROL
Please, read this manual carefully before operation.
1.Speaker
2. Power
3. Band selector
4. Pointer Dial
5. Dial scale
The lightning fl ash with arrowhead
symbol within an equilateral triangle,
is intended to alert the user to the
presence of uninsulated dangerous
voltage within the products enclosure
that may be of suffi cient magnitude
to constitute a risk of electric shock
to persons.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
CAUTION: THE RADIO MUST NOT BE USED IN ANY ENVIRONMENT WHERE IT MAY BE SUBJECT
TO THE DRIPPING OR SPLASHING OR WATER OR OTHER LIQUIDS.
Mains plug is used as the disconnect device. It shall remain readily operable and should not
be obstructed during intended used. To be completely disconnected the apparatus from
supply mains, the mains plug of the apparatus shall be disconnected from the mains socket
outlet completely.
OPERATION
1. Open the battery compartment at the back of the radio to install batteries or plug the
power cable in the lateral part of the radio.
2. Insert the mains plug into a suitable 230V AC mains socket.
3. Fully extend the radio aerial in a vertical direction to obtain the maximum signal strength.
4. Turn the Power off / volume control to switch on the radio and adjust the volume level, the
power LED indicator will light up.
5. On the front of the unit you can select the band either AM / FM.
6. To select the desired radio station, turn the tuning control.
7. Adjust the volume knob again to desired listening level.
6. Antenna
7. Handle
8. Tuning control (TUNING)
9. Volume control (VOLUME)
10. Earphone jack
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK
OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK), NO USER
SERVICEABLE PARTS INSIDE, REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
The exclamation point within an
equilateral triangle, is used to indicate
that a specifi c component shall be
replaced only by the component
specifi ed in that documentation for
safety reason.

Publicidad

Tabla de contenido
loading

Tabla de contenido