Cramer 2900586 Manual De Instrucciones página 5

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio or television reception. The reception
can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
4 SYMBOLS ON THE MACHINE
You can use below symbols on the machine. Please study
them and learn their definitions. Correct interpretation of
these symbols let you operate the tool better and safer.
Symbol Explanation
Class II
Before charging, read the instructions
Fuse
IPX IPX4
5 RISK LEVELS
The following signal words and meanings are intended to
explain the levels of risk associated with this product.
SYM- SIGNAL
BOL
DANGER
WARNING
NOTE
MEANING
Indicates an imminently haz-
ardous situation, which, if not
avoided, will result in death
or serious injury.
Indicates a potentially hazard-
ous situation, which, if not
avoided, could result in death
or serious injury.
English
SYM- SIGNAL
BOL
CAUTION
CAUTION
6 RECYCLE
Separate collection. You must not discard
with usual household waste. If it is necessa-
ry to replace the machine, or if it is no more
use to you, do not discard it with household
waste.
Separate collection of used machine and
packaging let you recycle materials and use
them again. Use of the recycled materials
helps prevent environmental pollution and
decreases the requirements for raw materi-
als.
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a location that accepts lithium-ion bat-
teries.
7 OPERATION
7.1 CHARGE PROCEDURE
See Figure 2.
Before use charge the battery pack fully to make sure that
the battery pack can get the maximum run time. This battery
pack does not have a memory. You can charge it all the
time.
1. Connect the plug of charger to an AC power outlet.
2. Lift the battery cover (2) by pushing the cover release
button (8).
3. Put the battery pack (9) (not included) into the charger.
Push the battery release button (10) to take out the
battery.
This is a diagnostic charger. The Charger LED Light (7)
illuminates in a specified order to show the current battery
status. They are as follows:
5
MEANING
Indicates a potentially hazard-
ous situation, which, if not
avoided, may result in minor
or moderate injury.
(Without Safety Alert Sym-
bol) Indicates a situation that
may result in property dam-
age.
NOTE
NOTE
EN