Publicidad
Idiomas disponibles
Idiomas disponibles
Note - connection impaired
After the FM transmitter and device have been
paired, a connection is established automatically.
If the Bluetooth
connection is not established
®
automatically, check the following:
• In the device's Bluetooth
whether BT21H is connected. If not, repeat the
steps listed under Bluetooth
• Check whether the device and FM transmitter
are less than 10 metres apart. If not, move
them closer together.
• Check whether obstacles are impairing the
range. If so, move the devices closer together.
5.2 Audio playback (via Bluetooth
Start and control audio playback accordingly on the
connected device. Alternatively, the audio playback
can also be controlled from the FM transmitter
(provided the connected device supports this).
• Press the function key
audio playback.
• Press the function key
track.
• Press the function key
5.3 Audio playback
(via USB stick or micro-SD card)
• Insert the USB stick into the USB socket marked
with
(2). Playback starts automatically.
• Insert a micro-SD card into the card slot (6) on the
FM transmitter. Playback starts automatically.
Note
• The capacity of the USB stick or micro-SD card
must not exceed 32 GB.
• Only the following formats can be played
back: MP3.
5.4 Manual station search
• Search for a free frequency (noise without signal
fragments) on your car radio.
• Set the same frequency on the FM transmitter. To
do this, press the
until the frequency indicator on the display (3)
starts flashing.
• Then set the desired frequency by pressing the
<
>
or
keys.
• The FM transmitter always automatically stores the
last frequency set.
4
settings, check
®
pairing.
®
)
®
to start or stop the
>
to skip forward one
<
to skip backwards.
button (5) for approx. 2 sec.
Note - Automatic standby
• The FM transmitter switches off automatically
after approx. 50-60 sec. without a music signal
or key input (standby).
• The FM transmitter is reactivated by a music
signal or key input.
5.5 Charging function
The FM transmitter has a USB charging socket. This
supplies the charging currents speci ed in Point 6. of
the technical data.
Note - car battery
With some vehicles, it can happen that power
continues to be supplied even though the ignition
has been switched off. You should therefore
disconnect the product from the line connection
when not in use to protect your car battery from
being drained.
Note - connecting devices
• Before connecting a device, check whether it
can be adequately supplied with the charger's
current capacity.
• Ensure that the total current consumption of
all the connected devices does not exceed
3000 mA.
• Note the instructions in your device's operating
manual.
• Disconnect all cable and mains connections
after use.
Note – QC 3.0, 2.0
• Plug & GO: no additional software required,
simply plug in and start:Thanks to QC 3.0,
2.0, the voltage and power are adjusted
automatically.
• Be aware that, for e cient and optimised
charging, your device must support the QC 3.0,
2.0 function.
• If you have a large number of QC-enabled
devices with different rmware updates, it may
be that the function is not fully supported.
Publicidad
