Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Tools Needed:
*Level
*Screw Driver
Important: Ensure that the supply cables is well mounted and that it does not come into
contact with reflector of the heater or that does not trail into heated area.
1.This heater should be installed by a competent person, i.e. a qualified electrician.
2.Always disconnected the heater from the electricity supply and allow it to cool before
installation.
3.This heater can be heat directly.
4.The supply cable must be at the lower end of the heater if the heater is installed at an
angle or vertically.
5.Keep the supply cord away from the body of the heater which will get hot during use.
6.Do not install the heater on an inflammable surface.
7.Observe the minimum safe distance between the heater body and the inflammable
surfaces when mounted.
8.If the heater is to be used outside, a weatherproof outlet is recommended.
9.Before drilling ensure that there are no wires or water pipes in the area where the heater
is to be installed.
10.The heater must be installed on the mounting brackets provided.
11.Fasten the brackets securely to the mounting surface and the backside of the heater
using the nuts and screws supplied.
12.Fasten the heater securely on the brackets using the nuts and bolts supplied.
*Power Drill and drill bits
○
,1chain-1pc
○
,2carabiners-2pc
12
Publicidad
