Kingfisher BI45DISHUK Manual Del Usuario página 58

Before you start
Remove all packaging materials from the dishwasher.
Connect the plug to the power supply and switch on; the dishwasher will beep once and you are
ready to set up for first use.
Follow these steps to set up your dishwasher for first use.
Before using your dishwasher for the first time you must:
1. Set the water hardness to suit your local water supply.
2. Fill the salt container with dishwasher compatible salt.
3. Fill the rinse aid container with dishwasher compatible rinse aid.
4. Add dishwasher powder or a capsule suitable for the first wash.
01 Water Hardness
The water softener is designed to remove minerals such as calcium carbonate from the water supply, which
would have a detrimental effect on the operation of the appliance. The higher the content of these minerals,
the harder the water is. The softener should be adjusted according to the hardness of the water in your area.
Please contact your local water utility company for the hardness of the water in your area.
Setting the water hardness
The appliance water hardness can be set from H1 (very soft) to H6 (very hard).
Dishwasher salt is not required for very soft water at H1.
1. Determine the water hardness from your local water utility company. This information is often found on
their website by searching with your post code.
2. There are many different methods for reporting water hardness dependent on your local country. The
most common versions are found in the Water Hardness table below.
3. Determine the correct appliance setting (H1 - H6) from the Water Hardness Table using the information
from your local water utility company. If your water hardness scale is not captured in the table,
conversion charts are available on the internet.
4. Open the door.
5. Press the Power button
6. Within one minute of turning on the power, press the Program button [P] for more than five seconds to
enter the Water Hardness mode. H3 is the factory default setting.
7. Press the Program button [P] to cycle though the settings H1 - H6 until this matches your local water
supply and press [P] again to store the setting.
Water Hardness Table
Appliance Setting
H1 = Rapid light on
H2 = 90 Min light on
H3 = 90 Min & Rapid lights on
H4 = ECO light on
H5 = ECO & Rapid lights on
H6 = ECO & 90 Min lights on
5059340445755_MNL_IN_V09.indb 58 5059340445755_MNL_IN_V09.indb 58
to turn on the appliance.
Clarke Degrees (°e)
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
58
Water Hardness
French Degrees (°fH)
0 - 9
10 - 20
21 - 30
31 - 40
41 - 60
61 - 98
Millimoles (mmol/L)
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
31-03-2022 15:28:23 31-03-2022 15:28:23