Livoo TES242 Manual De Instrucciones página 7

AUDIO
Rated output power
Frequency response
Signal to noise ratio
Drawing of the device
Figure 1
1. Induction charging slot
2. Outer face of the light ring
3. Light ring
5. Port type C
7. Speaker
Use of the device
INDUCTIVE CHARGING
This product has a wireless charger with simple design and compatible with any mobile phones with QI
standard. Mobile phone is without plug when charging. If your mobile is not QI you can still enjoy this product
by using the wireless receivers (not included).
1. Plug the USB port of the USB data cable to the power adapter and the Type C end to the wireless
charger.
2. After the product is powered on, the product indicators flash blue and white.
3. Place the device that needs to be charged in the charging indication area of the product, the white
indicator light goes out and the blue indicator light comes on, the blue light stays on and enters the
charging state.
Unplug the wireless charger after use.
Note : This product supports fast wireless charging function, meets the QI wireless standard charging
standard, and realizes short-range wireless energy transmission by magnetic induction. This device
supports all QI standard wireless charging devices. When a 5V output adapter is used, the wireless
charger supports 5W load, suitable for QC2.0 and above adapters, wireless charging gas supports 15W
load, with overcharge protection (9V) and overcurrent protection (2A).
USE OF THE LIGHT
.
1 Touch the first time to start the light 10% brightness
2. Touch the second time to change the light 60% brightness
3. Touch the third time to change the light 100% brightness
4. Touch the fourth time to turn off the light
BLUETOOTH COMPATIBLE SPEAKER
When the unit is turned off, press and hold the playback button
sound. The speaker is trying to pair. Activate the Bluetooth function of your mobile phone. Select the
name of the TES242 device, the pairing is done automatically. After successful pairing, the indicator light
stops flashing.
If the product is not paired for 10 minutes, the Bluetooth indicator on the speakerphone stops flashing
and turns off automatically.
1*5W(RMS)
100-18 Khz
85 dB
www.livoo.fr
GENERAL INFORMATIONS
Input
Built in battery
Size
Weight
Figure 2
4. Function buttons
6. Touch switch for lighting
for about 3 seconds. A beep will
DC 5V, 2.1A ; DC 9V, 1.67A
3.7 V 1500 mAh
Ø18x 52mm
545 g