Watts LF007 Serie Instrucciones De Instalación página 9

Continued
REGISTER DESCRIPTION
40103 Setup Channel 6
40114 Trim Zero, 10V
Range
40115 Trim Zero, 5V Range
40116 Trim Zero, 1V Range
40117 Trim Zero, 0.1V
Range
40118 Trim Zero, 0.05V
Range
40119 Trim Zero, 0.025V
Range
40146 Trim FS, 10V Range
40147 Trim FS, 5V Range
40148 Trim FS, 1V Range
40149 Trim FS, 0.1V
Range
40150 Trim FS, 0.05V
Range
40151 Trim FS, 0.025V
Range
40241 Control Register
FUNCTION VALUE
R/W 0-F
WP 0
WP 0
WP 0
WP 0
WP 0
WP 0
WP D000-FFFE
WP D000-FFFE
WP D000-FFFE
WP D000-FFFE
WP D000-FFFE
WP D000-FFFE
W
9
DESCRIPTION
Holds Channel 6 range.
Factory set to 0x0001.
Forces all Channel Data Registers to 8000h,
with input signal equal to zero. Apply
calibration signal at least 15 seconds
before calibrating to all channels. Calibration
Acknowledge Exception Response.
Calibration takes 20 seconds.
Refer to Modbus register 40114.
Refer to Modbus register 40114.
Refer to Modbus register 40114. Apply
calibration signal at least 1 minute before
calibrating to all channels.
Refer to Modbus register 40114. Apply
calibration signal at least 1 minute before
calibrating to all channels.
Refer to Modbus register 40114. Apply
calibration signal at least 1 minute before
calibrating to all channels.
Forces all Channel Data Registers to written
value, with appropriate input signal. Apply
calibration signal at least 15 seconds before
calibrating to all channels. Acknowledge
Exception Response. Calibration takes
20 seconds.
Refer to Modbus Register 40146.
Refer to Modbus Register 40146.
Refer to Modbus Register 40146. Apply
calibration signal at least 1 minute before
calibrating to all channels.
Refer to Modbus Register 40146. Apply
calibration signal at least 1 minute before
calibrating to all channels.
Refer to Modbus Register 40146. Apply
calibration signal at least 1 minute before
calibrating to all channels.
0 – Normal operation (NOP)
1 – Remote Reset (write protected)
2 – Write Enable
5 – Initialize Host Communication setup