Charger And Battery - VORAGO BTE-400 Guía Rápida

INSTRUCTIONS FOR USE
Fully charge the headset before start.

Charger and Battery

The headset is embedded with non-removable charging
battery. D o n ot a ttempt t o r emove t he b attery f rom the headset;
otherwise, the headset may be damaged. If the headset is not
used in a long time, keep it in a dry and well-ventilated place,
and charge the headset once every two months.
1. If the red indicator blinks with a voice prompt "Battery Low",
the headset battery is low. If the headset continues to work,
it may be automatically powered off. At this time, you need to
charge the headset by connecting the cable of the charger to
the charging port on the headset.
2. Connect the charger to an AC power socket.
3. The red indicator is on when the headset is being charged. If
the charging is not started yet, disconnect the headset from the
power socket, and reconnect the headset again. It takes about
2 hours to fully charge the headset. After battery charging is
completed, the red indicator is off, and the blue indicator is on.
At this time, you can disconnect the charger from the power
socket and headset.