STACK-ON QAS-1510 Manual De Instrucciones página 2

GETTING STARTED
When you rst receive your safe you will need to
open the drawer with the key and remove the
drawer in order to install the ba eries. Ba eries
are included and are located inside the drawer.
NOTE: is key has also been provided if you lose
or forget your security code or the ba eries run low.
If you lose your key, you may purchase a replacement
key by referencing the serial number located on the
front of the drawer. See section regarding
replacement keys for further information.
To open the safe, insert key into lock and turn
clockwise until the drawer automatically opens.
NOTE: You must turn the key back to the
locked position before you are able to close and
lock the drawer.
REMOVING THE DRAWER
REMOVING THE DRAWER
Remove the foam drawer liner. Pull the drawer all the
way open. Locate the access hole. Using a small
screwdriver or pointed tool, move the clear tab to the
right and pull the drawer o the slide as shown.
NOTE: You can also access the tab by reaching
under the drawer and moving the tab with your
nger. If the safe has been mounted to a permanent
shelf, you will have to remove the drawer as
described above.
2
14
40706-1608