Publicidad
Idiomas disponibles
Idiomas disponibles
▪ When the cutting blade locks or the cutting work is
interrupted for any reason, immediately release the
"ON/OFF" switch and keep the saw still on the
workpiece until the blade stops completely;
▪ Never pull the saw backwards or try to take it out of
the workpiece while the blade is moving, otherwise
you may lose control of the saw;
▪ To prevent any displacement of the workpiece, use
fixing devices or a workbench to ensure that the work
is performed safely. Place and keep the workpiece in
the correct and secure position;
▪ Make sure that the ventilation grids are not
obstructed during operation. Do not insert any
objects into the ventilation grids;
▪ The cutting blades may become too hot during
operation. Avoid touching them, they may burn;
▪ Make sure you do not damage electrical circuits, gas
and water pipes when working with the tool. Any
damage to these elements may cause fire, explosion,
electric shock or material damage;
▪ Avoid using the tool on surfaces coated with paints
that contain lead or other materials harmful to
health. Contact with or inhalation of dust may cause
allergy reactions and/or respiratory diseases.
Maintenance and cleaning
Remove the battery from the power tool before start
cleaning, adjustment, repair or maintenance work.
Replace worn out or damaged parts immediately so that
the power tool is always operational and in a safe
operating condition.
Cleaning
Always keep the power tool clean and dry, free of oil,
grease and lubricants.
accessories of the power tool after use.
Do not use strong cleaning agents. These products can
damage plastics and metals and impair the safe
operation of your power tool.
Maintenance work
Maintenance work may only be carried out as described
in these operating instructions; all other work must be
carried out by an official dealer.
Clean all components and
Keep all nuts and screws well tighten so that the power
tool can operate safely.
If components or safety devices are removed for
maintenance work, they must be replaced correctly
immediately.
Use only blades or attachable accessories authorized by
VITO for this power tool or technically identical parts.
Otherwise injury or damage to the power tool may
occur. In case of doubt or if you lack the necessary
knowledge and means, you should contact an official
dealer.
Technical Assistance
Your cordless screwdriver should only be serviced
by the manufacturer's internal service personnel,
or other qualified personnel, replacing any necessary
parts with original parts sourced directly from the
manufacturer.
23
Publicidad
