Publicidad
Este equipo ha sido previsto para la alimentación de corriente a través de una fuente listada con tensión limitada, corriente
]
limitada o clase 2. Este equipo debe ser alimentado a través de un módulo de cable/conector listado (CYJV) con por lo
menos 24 V de corriente continua y 0,8 A.
FCC/IC - Nota
This device complies with Part 15 of the FCC Rules and contains licence-exempt transmitter/receivers that are
compliant with ISED (Innovation, Science and Economic Development) Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference signals, and
(2) This device must be able to tolerate interference signals. These also include interference signals that could
cause the device to function improperly.
This device complies with the nerve stimulation limits (ISED SPR-002) when operated at a minimum distance of 100
mm. Changes or modifications not expressly approved by K.A. Schmersal GmbH & Co. KG could void the user's
authority to operate the equipment.
The licence-free transmitter/receiver contained in this device satisfies the requirements of the "Radio Standards
Specification" of the Innovation, Science and Economic Development Canada (ISED) authority that apply to licence-
free radio equipment. Operation is permissible under the following two conditions:
(1) The device must not create disturbances.
(2) The device must tolerate received radio frequency interference, even if this could impair its functionality.
This device complies with the nerve stimulation limits (ISED CNR-102) when operated at a minimum distance of 100
mm.
In the event of changes or modifications that have not been expressly approved by K.A. Schmersal GmbH & Co. KG,
the user's authorisation to use the device may become ineffective.
3 Montaje
3.1 Instrucciones generales para el montaje
Rogamos observar las instrucciones de las normas EN ISO 12100, EN ISO 14119 y EN ISO 14120.
2
Para la fijación del dispositivo de seguridad con bloqueo y del actuador, se dispone de dos taladros de sujeción para
tornillos M6 (par de apriete: 6 ... 7 Nm).
La posición de montaje es libre. La operación del sistema sólo está permitida si se mantiene un ángulo entre
dispositivo de bloqueo y actuador ≤ 2°.
Publicidad
