HAMPTON BAY LDS-BF3001 Guía De Uso Y Cuidado página 4

SPECIFICATIONS
Airflow: 160 CFM Main light: 1500lm Night light: 2200K
Voltage: 120 V, 60 Hz
Duct diameter: 6 in.
Sound output: 1.1 Sones
Typical Installation
The ducting from this fan to the outside of the
energy use of the fan. Use the shortest, straightest
duct routing possible for best performance, and
avoid installing the fan with smaller ducts than
recommended. Insulation around the ducts can
reduce energy loss and inhibit mold growth. Fans
installed with existing ducts may not achieve
Wiring Diagram
ground white black
fan switch
(purchased separately)
The FAN wires
cannot be
connected to a
dimmer switch
black
Ground 120V line AC
Properly insulate
around fan to
minimize building
heat loss and gain
fan
fan light
white
black
light switch
(purchased separately)
The LED light
can be
connected to a
dimmer switch
black
Power consumption: Fan 38W, Light 20W
Weight: 13.45 lbs.
Ceiling Opening Dimension Requirements: 12.17 in. (L) x 11 in. (W).
duct helps alignment
Fan housing
and absorbs sound
Seal any gap around
fan housing
2-3 foot straight run
before elbow
WARNING: Wiring must comply with all applicable electrical
codes. Turn OFF power before removing or installing connectors
WARNING: COPPER TO COPPER ONLY. Do not use Aluminum wire.
4
SPECIFICATIONS
Roof cap (with
built-in damper)
OR
Caulk
termination
to duct
Wall cap
(with
built-in
damper)