Publicidad
Idiomas disponibles
Idiomas disponibles
Installation - New Construction (continued)
4
Connect the wire
Loosen the short screw (E) and remove the wire cover (F).
Pull the house wires through the knockout of wire cover (F).
Using the quick connectors to connect 120 V AC house
wiring from the wall switch to the fan as shown in the
wiring diagram on page 3.
Carefully push the connected wires back into the wiring
compartment of the fan housing (A). Reattach the wire
cover (F) and attach it firmly with the short screw (E).
NOTE: Attach the 1/2" ROMEX connector or 1/2 "Flexible Metal Conduit
connector (supplied by others) to wiring compartment cover and lock in
place with 1/2 lock nut included with connector.
If the electrical wires do not match the colors
CAUTION:
listed, you must determine what each house wire represents
before connecting. You may need to consult an electrical
contractor to determine safely.
5
Connect the duct
Connect a 6 in. circular duct (not supplied) and vent to the
duct connector. Secure it with duct tape (not supplied) or a
clamp (not supplied) to make the connection secure and
air tight.
Turn on the power source. Check the fan for any abnormal
sound or vibration.
6
Finish the ceiling work
After electrical and construction inspection is completed,
the dry wall ceiling can be installed.
Cut the ceiling hole with the cut-hole template (H) or the
size 11*12.17inch (280*309mm). Ceiling hole should be
aligned with the inside edge of fan housing.
Important: Cover and seal up all gaps with duct tape
NOTE: That it is common practice in heating and ventilation
systems using sheet metal ductwork and fittings or flexible duct
work tubing to use duct tape or aluminum tape to ensure air
tight seals and improve efficiency.
7
Install the grille with light
Attach the grille by squeezing one spring together and inserting
the springs into the spring guides in the fan housing (A) firstly.
Connect LED wire to the plug in the fan housing.
Then insert another spring and push the grille (B) up against
the ceiling.
Check that the installation is secure and safe from falling objects.
White
Green to Green
F
Black
E
After checking the
CAUTION:
fan, please remember to turn
off the power before next
installation step.
NOTE: If you have to connect to 4in.
circular duct, please use a 6in. to 4in.
duct adapter (not supplied).
Duct tape
Gaps
Plug
8
Ground- Green or copper wire
Neutral-White to White wire
Line-Black to Black wire
A
E
TEMPLATE
Duct tape
Publicidad
