Toro Tempus Air PS Guia Del Usuario página 5

Step 4
SENSOR INSTALLATION
1. Get closer than 10 meters from Tempus Air PS and make sure your smartphone's Bluetooth is turned on.
2. Launch MyToroTempus app from your smartphone or tablet.
3. Select the Tempus Air PS previously installed. (The smartphone and Tempus Air PS module, must be connected via
Bluetooth)
4. Click on "Add a sensor"
5. Select the type of sensor you want connect to your Tempus Air PS.
6. Select the sensor you want connect to your Tempus Air PS.
7. To properly connect the wiring and complete the sensor installation, follow the next steps described in the app.
1 input model : analog 0-5 V Pressure Sensor.
Support capteur de pression
Red wires: 5V power supply
The sensor's wires are directly wired to the products at the factory. Only the sensor can be disconnected thanks to
its waterproof Metripack-150 connector.
Connecteur Metri‐Pack 150
The sensor used makes it possible to measure the pressure of the irrigation system from 0 to 16 bars. It will be
installed on the system thanks to its G1/4 EN837 screw thread.
2 2 . . I I
D D E E N N T T I I F F I I C C A A T T I I O O N N D D E E L L
Metripack-150 connector
' '
A A N N C C I I E E N N C C A A P P T T E E U U R R D D E E P P R R E E S S S S I I O O N N
Toro Tempus Air PS
Data 5 V
Fourni uniquem
Filwat Compact
5