Adjusting the set temperature:
By holding down the button on the controller until the display flashes, you enter the adjusting mode for the set
value. This can be set in 0.5 °C increments between 18 °C and 34 °C. After the setpoint adjustment, the
controller stops flashing a short time later and the heater is in working mode.
IMPORTANT!! The controller does not accurately measure and display the real temperature. An
additional temperature measurement using a sufficiently accurate thermometer in the aquarium is
essential. If necessary, the setpoint has to be adjusted accordingly.
3. Maintenance
To achieve best results of the heater, it must be checked regularly. Check whether the USB plug is protected
from moisture, condensation and splashing water. Do not continue to operate heaters with corroded plugs. Dirty
heaters must be cleaned regularly to ensure good heat transfer. Also the sucker should be cleaned regularly to
ensure it has sufficient grip.
4. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear. The original
invoice or receipt is required as proof of purchase. During the warranty period, we will repair the product for
free by installing new or renewed parts. This warranty only covers material and processing faults that occur
when used as intended. It does not apply to damage caused by transport, improper handling, incorrect
installation, negligence, interference or repairs made by unauthorized persons. In case of a fault with the
unit during or after the warranty period, please contact your dealer. All further steps are clarified
between the dealer and AB Aqua Medic. All complaints and returns that are not sent to us via
specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages resulting
from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
- Technical changes reserved – 04/2023/v2
5