Publicidad
Idiomas disponibles
Idiomas disponibles
must always point upwards when viewed from the front of the saw.
Always use protective gloves when handling the blade. Never put your hand under the saw or try to
remove material from the working area while the blade in rotating. Never place your fingers or hand
on the item being cut in front of or behind the saw while it is running.
Never lock the blade guard in its open position except when changing blades as described below.
Check that the guard can be moved freely and that the closures mechanism works correctly before
use. Do not use the saw if this is not the case.
Always keep the spindle and flanges for fitting saw blades clean.
Never allow the blade to be in contact with the item to be cut or other objects when starting the saw.
Check that there are no nails, screws or other objects that could damage the blade in the item to be
cut, and that the surface under the item will not hinder cutting.
Never mount the saw in a vice or similar with the blade uppermost to cut items in this way. Serious
accidents can occur.
- Sawing
Always secure the item to be cut in a vice or similar. Never use your hand to keep the item steady.
Adjust the cutting depth by loosening the lock knob (3), adjust the height of the base plate in relation
to the blade and retighten the lock knob.
If necessary, adjust the bevel angle by loosening the bevel adjustment knob (5) and tilting the blade
to the required angle (0-45° to the vertical; can be read off the angle gauge). Retighten the bevel
adjustment knob.
Fit the side guide (7) in its bracket (6) on the base plate and secure. If you need to cut in item further
from the edge, beyond the reach of the side guide, you must attach a straightedge to the item using
a clamp.
Check that the saw is set up correctly and that all knobs and bolts are correctly tightened before
starting to saw.
Press the safety switch (1) and the on/off switch (2) on the handle. Allow the saw to reach full speed
before starting to cut the item.
Place the motor section of the saw on that part of the item not being sawn off.
Hold the saw by the handle and front grip and cut in a straight line. Do not force the saw sideways.
Switch the saw off immediately if the blade jams or gets stuck in the item being cut. If the blade gets
stuck, it may cause the saw to kick back violently towards the user.
Never lift the saw from the item until the blade has come to a complete stop and never put the saw
down unless the blade guard is fully closed.
5. BLADE REPLACEMENT
1. Press the button of spindle lock.
2. Loose the screw with hex key clockwisely.
3. Remove the washer, upper bridge, then take out the blade.
4. Replace the balde, then install it following above instructions.
6. CLEANING AND MAINTENANCE
To clean the saw wipe its external parts with a damp cloth.
From time to time lubricate moving parts with oil.
- Environmental information
You can help protect the environment!
Follow total environmental regulations:
Dispose of unwanted electrical equipment at an approved recycling station.
3
Publicidad
