Publicidad
Status
Wizard
Quick Set
Advanced
Upgrade
Restart
Reset
9. Vuelva a conectarse a la red AP de loggeer, luego inicie sesión en
10.10.100.254 mediante el navegador, y verifique la información del sistema de
la página "Estado". Una vez realizada la configuración de la red, el servidor
remoto A o B debe estar "conectado".
Status
Wizard
Quick Set
Advanced
Upgrade
Restart
Reset
10.
Si tanto el servidor remoto A como el B están "No conectados", actualice la página
o repita los pasos anteriores. Si la "Calidad de la señal" es inferior al 40 %, acerque el
enrutador al microinversor.
Setting complete!
Click OK, the settings will take effect and the system will
restart immediately.
If you leave this interface without clicking OK, the settings
will be ineffective.
1
2
Inverter information
Inverter serial number
Firmware version(main)
Firmware version(slave)
Inverter model
Rated power
Current power
Yield today
Current power
Alerts
Last updated
Device information
Device serial number
Firmware version
Wireless AP mode
SSID
IP address
MAC address
Wireless STA mode
Router SSID
Signal Quality
IP address
MAC address
Remote server information
Remote server A
Remote server B
- 22 -
Back
OK
3
4
The device can be used as
a wireless access point(AP
mode) to facilitata users to
configure the device, or it
can also be used as a
W
wireless information terminal
(STA mode) to connect the
W
remote server via wireless
---kWh
router.
---kWh
Status of remote server
Not connected: Connection
to server failed last time.
If under such status, please
check the issues as follows:
check the device
(1)
information to see whether
1704013242
IP address is obtained or
LSW3_14_FFFF_1.0.23
not;
check if the router is
(2)
Disable
connected to internet or
not;
check if a firewall is
(3)
set on the router or not;
Connected: connection to
Enable
server successful last time;
IE-2.4G-TEST
Unknown: No connection
to server. Please check
100%
again in 5 minutes.
172.16.30.247
98:D8:63:71:8D:B0
connected
Not connected
Help
After clicking OK,the
system will restart
immediately.
Help
Publicidad
