Publicidad
Idiomas disponibles
Idiomas disponibles
Adhesive surface only
bonds on one side.
Adhesive bond
doesn't work after
cooling.
Glued tiles in moist
locations are not
adhesive.
Glued shoe soles are
not adhesive.
Strands are pulled
out when removing
EN
the glue gun from the
work-piece.
12
Work-piece melts.
Burns on fingers when
applying adhesive.
Adhesive already partially
has cooled off before
work-pieces have been
bonded.
Surface is greasy or too
smooth.
Surface is dusty.
Unsuitable material or
work-piece.
Moisture spreads under
bonding parts.
Moisture causes leather
to puff up and creeps
under bonding location.
Trigger is still pressed
after operation.
Nozzle has not been
wiped off.
Work-piece contains
material that melts at a
low temperature.
Adhesive penetrates
through paper/ fabric/
tissue
Metal work-piece has
heated up.
Bond work-pieces in a
quicker way.
Set gluing points instead
of applying glue over
surface.
Roughen adhesive
surface slightly.
Clean the surface.
Use specialized
adhesive.
Suggest to use
specialized adhensive
suitable for moist
locations
Use specialized
adhesive.
Discontinue pressing
trigger before
completing the
operation.
Wipe off nozzle.
Use specialized
adhesive.
Do not hold work-piece
in hand.
Apply adhesive with
work-piece placed on
heat-resistant silicone
pad or base.
Do not hold work-piece
in hand.
Apply adhesive with
work-piece placed on
heat-resistant silicone
pad or base.
Clamp work-piece.
Publicidad
