4. When turning on,
massage mode
will begin. Use
the increase and
decrease buttons to
find a comfortable
suction level.
7. Stop pumping
when the milk stops
flowing or when the
bottle is full.
Note:
• The pump will run for 30 minutes before automatically turning off. A single
expression should not last longer than 20 minutes.
• To return to expression mode from rapid mode, press and hold the mode
switch button for 2 seconds. To switch between massage mode and
expression mode, press the mode switch button. Massage mode cannot
be accessed from rapid mode.
• Night light has 2 brightness settings. Press the light button to cycle between
OFF, low brightness and high brightness.
8
5. After 2 minutes,
expression mode
will automatically
begin. Again, select
a comfortable
suction level using
the increase and
decrease buttons.
8. Remove the electric
pump unit (and
tube) from the
bottle assembly.
6. For a faster
expression, switch
to rapid mode
by pressing and
holding the mode
switch button for 2
seconds.
9. Unscrew the bottle
from the shield
connector. Use
the bottle cap
to seal the bottle
for storage or the
feeding teat for
feeding.