Elpress EWG-S 1 - 6 Manual De Uso página 10

6
6.1 General
EN
6.2 Use during evacuation
7
Instruction
- Approach the wash basin from the front.
- The sensor is activated when entering the system (approx.
100 mm from the lens).
- The Dyson Tap starts delivering water as soon as the hands are
held under the tap.
- The knee operated valve must be depressed with the knee.
- The water starts to flow and hands and/or underarms can be
cleaned.
- The water supply shuts off immediately when moving outside the
range of the sensor.
- When the knee operation valve is released, the flow of water will
stop after a while.
- If both hands are held at the sides of the Dyson Tap, the air flow
will start up. The air blade is used to dry the hands by repeatedly
moving them forwards and backwards.
SENSOR OPERATED
10
Intended use
• The installations are intended solely for washing the hands and
underarms.
• The installations are intended solely for washing the hands and/or
underarms as well as for automatic hand drying.
EWG-TAP
• To start the installation, connect it to a power supply.
SENSOR OPERATED / EWG-TAP
• Switch the installation off by disconnecting it from the power supply.
The consequence of this is that the machine no longer gives out any
water.
SENSOR OPERATED
Instruction table
Hand cleaning*
* Time settings are to be adjusted to your preference. See: Technical documentation:
Legionella prevention system.
Sensor Knee
operated operated
√ √
√
√
√ √
√
√
EWG–TAP
√
√
√
√
√
2021-10-19