Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – Prevail Petite / USSL Petite
INSTALLATION
This fixture must be stored in a dry location prior to
N
ote:
installation. Do not expose fixture to rain, dust or
other environmental conditions prior to installation
and insertion of photocontrol or shorting cap (if so
equipped).
N
ote:
This lighting fixture has been shipped complete.
Please follow the installation instructions specific to
the catalog part that you ordered.
Care must be taken not to set lighting fixture down
N
ote:
on optical lenses or lift the fixture by the lens.
Pole Mount Arm
Tools Required
Ratchet, 3/4" socket, 3/4" wrench, #2 Phillips head
screwdriver and torque wrench.
1.
Pole mounting arm is designed for a square or round
pole. Round pole installation will require the mounting
arm break away tabs to be removed. Grab break away
tab with pliers and break-away the tab. (Figure 1.)
For Round Pole
Installations,
Break away Tabs
Figure 1.
2.
Mount the arm to the round or square pole using the
provided 1/2" x 1-3/4" long bolts and nuts as shown.
Torque bolts to 40 foot-lbs (55 N-M). (Figure 2.)
Split Washer
Washer
1/2" Bolt
Washer
Figure 2.
2
Cooper Lighting Solutions
9/16" (14.3mm)
Diameter Hole and
Slot
7/8"
4-7/8"
(22mm)
(124mm)
1/2" Nut
IB514105EN
Installation instructions
3.
Fold fixtures wires tightly towards fixture door when
sliding fixture on to mounting arm. Tighten the center
Phillips head screw to 20 in-lbs (2.3 N-M). (Figure 3.)
Close-Up View
Figure 3.
4.
Make wire connections inside the mounting arm.
Refer to wire diagram for power connection
(Figure 4.). Connect the supply wires to appropriate
luminaire leads:
• Supply side ground wire to green luminaire lead.
• Supply side neutral wire to white luminaire lead.
• Supply side line voltage wire to black luminaire lead.
(+) Line
(-) Common
Ground
Dimming Control
0-10V
Figure 4.
N
ote:
*Constructions built before Jan 2022 may have gray
wire for 0-10 dimming control present. In these
cases, the installer will label the gray building wire
as a 0-10 dimming wire and connect to our product's
pink 0-10V dimming control wire. Reference NFPA70
(2020 NEC), section 410.69.
Cover Plate Screws
Figure 5.
Center Phillips Head Screw
Black
White
Green
Fixture
Pink
Purple
Cover Tabs
Publicidad
