Publicidad
Idiomas disponibles
Idiomas disponibles
INFANT CAR SEAT
INFANT CAR SEAT
WARNING:
To avoid
serious injury from falling or
sliding out, always use the Infant
Car Seat harness.
•
ONLY
approved Snap Gear™ products can be
used on the frame.
TO ADJUST THE CAR SEAT HEIGHT
WARNING:
Do not adjust
car seat height with child in seat.
Adjust seat height before placing
your child in the car seat.
WARNING:
Always
check that the Height Adjustment
Bracket is level and both left and
right sides locked before placing
child in the car seat.
WARNING:
Never use
the car seat mode at any of the
higher positions. Always use the
car seat at the lowest position.
WARNING:
Never rest the
height adjustment bracket on the
locking pins.
24)
• Squeeze both left and right Release
Handles of the Height Adjustment Bracket
and adjust to the lowest position (Fig. 24a).
DO NOT adjust with child in the seat.
ATTENTION:
The Height Adjustment Bracket must be set at the
lowest postion before placing car seat (Fig. 24b).
17
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Handle
Fig. 24a
Lowest Position
Fig. 24b
INFANT CAR SEAT
TO ATTACH CAR SEAT
25)
• Connect the Car Seat and lock into place
(Fig. 25a). Make sure its locked firmly in
place before use (Fig. 25b).
TO REMOVE CAR SEAT
26)
• Detach Car Seat from Upper Frame
Assembly by pushing both center
buttons on each side of the seat and
lifting seat upwards (Fig. 26).
Fig. 25b
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 25a
Fig. 26
18
Publicidad
