Publicidad
Idiomas disponibles
Idiomas disponibles
-
Full automatic programming
This function is used to cook after a certain period of time, with a certain duration. The food to be cooked
is put into the oven. The oven is adjusted to the desired cooking function. The oven temperature is
adjusted to the desired degree depending on the food to be cooked.
First: Press "
" button until you see " Dur " on the timer screen. Use " + " " - " button to adjust cooking
period for the food you wish to cook. Press "
screen and the symbols " A " will begin to continuously light on the screen.
on the time screen, Use " + " " - " button to adiust finshing time, Press "
time will appear on the csreen and the symbol " A " will begin to continuously light on the screen. The
symbol "
" disappears until the time cooking starts.
You can set a time which can be up 23.59 hours after the time obtained by adding the
cooking period to the day's time.
The oven will start operating at the time calculated by deducting the cooking period from the set finishing
time, and will stop at the set finishing time. The timer will give an audible warning and the symbol " A "
will begin to flash. After bringing the cooking function and oven temperature knob to " 0 " position.
Pressing and button less than 3 seconds, it will stop the audible warning.
Pressing "
" for more than 3 seconds set the oven to Manual mode again to use the oven.
Please note: Once setting full-automatic mode, all the time can not be changed, Change time means
cancle automatice progamme and enter into corresponding mode. If you need to reset automatic mode,
need to stop setting the current mode, to set the automatice mode according to the above steps again.
Spectification
1> When setting the date of each function, long press on " + " or " - " for more than 3 seconds, the
date will progressively and rapidly increase or decrease.
2> When setting each of
manual mode.
3> When settiing each of the time function, pressing on "
current setting and enter manual mode.
4> During time function setting, pressing on " + " and "
can cancle the curent time function setting and enter standby mode.
5> We suggest that you run the oven elements for 15 minutes at 200 degrees to burn off any residuce
from their surfaces.
:
the time function,
if there is
" button to confirm, the day's time will appear on the
operation for 5 minutes then it will return to
none
" for more than 3 seconds can cancel
" for more than 3 seconds, a beep sounds it
EN-9
" button to confirm, the day's
Publicidad
