Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid accidents, always disconnect the battery pack from tool before ser-
vicing or cleaning.
Service
NO
PARTS INSIDE. Preventive
maintenance performed by un au thorized per-
sonnel may result in misplacing of internal
wires and components which could cause seri-
ous hazard. We recom mend that all tool service
be performed by a Bosch Factory Service Center
or Authorized Bosch Service Station.
Batteries
Be alert for battery packs that are nearing
their end of life. If you notice decreased tool
performance or significantly shorter running
time between charges then it is time to replace
the battery pack. Failure to do so can cause the
tool to operate improperly or damage the char-
ger.
Tool Lubrication
Your Bosch tool has been properly lubricated
and is ready for use.
Motors
The motor in your tool has been engineered for
many hours of dependable service. To maintain
peak efficiency of the motor, we recommend it
be examined every six months. Only a genuine
Bosch replacement motor specially designed for
your tool should be used.
The use of any other attachments or accessories not specified in this manual
may create a hazard.
Store accessories in a dry and temperate environment to avoid corrosion and deterioration.
Standard equipment
- JA1013 Anti splinter insert
- Bosch T-shank jig saw blade
- JA1012 Articulating Dust Extraction Kit
- Non-Marring Overshoe
160992A7EF_GST18V50_202203.indd 18
Maintenance
USER
SERVICEABLE
Accessories and Attachments
Bearings
Bearings which become noisy (due to heavy load
or very abrasive material cutting) should be re-
placed at once to avoid overheating and motor
failure.
Cleaning
Certain cleaning agents and
solvents
parts. Some of these are: gasoline, carbon tetra-
chloride, chlorinated cleaning solvents, ammo-
nia and household detergents that contain am-
monia.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through opening.
CLEANING BLADE HOLDER
Clean the saw blade holder regularly. For this,
remove the saw blade from the tool and lightly
tap footplate on a level surface.
Regularly spray penetrating oil onto the saw
blade holder.
Check the guide roller regularly. If worn, it must
be replaced through an authorized Bosch Fac-
tory Service Center
Lubricate the guide roller occasionally with a
drop of oil.
Optional accessories and attachments
- JA1010 Circle and parallel cutting guide
- Carrying bag
- Other Bosch T-shank jig saw blades
-18-
damage
plastic
3/25/22 11:47 AM
Publicidad
