Publicidad
Idiomas disponibles
Idiomas disponibles
VAPOPADS:
Your Vicks Vaporizer includes a Scent Pad heater so that you can enjoy
Vicks Soothing Menthol vapors to increase your comfort. Vicks Scent
Pads work with heat to gradually release soothing aromatic vapors. One
complimentary menthol vapor Scent Pad is included with your unit.
1) Open scent pad pouch at notch to expose pad. Do not touch exposed pad
directly. If you do touch a pad, be sure to wash your hands thoroughly.
2) Insert the scent pads into the slots located on the top of the steam unit
behind the steam outlet.
3) Vapor intensity can be controlled by using 1 or 2 pads. Insert 1 pad into
one slot for moderate scent release and insert another pad into the
second slot for maximum scent release.
4) Before changing or removing the pads unplug the steam unit from the
outlet and allow to cool for 20-30 mintues. Pads should be replaced after
8 hours of use.
Recommended Usage for the Vicks Menthol Scent Pad (VSP-19 / VSP-19-CAN):
-
Not recommended for infants under 10 pounds.
-
For children between 10-22 pounds do not use more than 2 pads in a 24
hour period.
Ingredients: Eucalyptus Oil, Menthol, Glycol, Cedar Leaf Oil & Others
Replacement VapoPads
can be purchased at most mass
®
and drug retailers or through Kaz Consumer Relations
or www.kaz.com/vicks. Use only the Vicks
models: In the US, VSP-19, VVP-6 or VBR-5. In Canada,
VSP-19-CAN. Other brands of replacement scent pads
may not be compatible with this vaporizor.
CAUTION: DO NOT place more than one pad in each slot.
CAUTION: DO NOT use any other pads or oils in the scent pad slots.
6.
PLUG IN. Plug the power cord into 110-120 Volts AC outlet in good
condition fused for at least 15 Amps. Do not use with extension cords.
This product has a polarized plug (one blade is wider than the other)
as a safety feature. This plug will fit into a polarized outlet only one
way. If the plug does not fit fully into the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. DO NOT ATTEMPT TO
DEFEAT THIS SAFETY FEATURE.
Vaporizer will produce a gentle flow of steam within a few minutes. If
steaming does not start within ten minutes, you may need to add salt.
Please see step 7 and the Troubleshooting checklist.
Vaporizer will automatically stop producing steam when water has
reached minimum level (about 3/4 inch from bottom of container).
The night-light will remain on, indicating that the vaporizer is plugged
in. ALWAYS unplug steam unit and allow to cool for 20-30 minutes before
removing from the water container.
6
All manuals and user guides at all-guides.com
VapoPads
®
®
Under conditions of rapid boiling and near the end
of each operation, steam may emerge from SAFETY
VENTS (above and on both sides of the steam vent).
This condition is normal, preventing over boiling
by relieving steam pressure
.
vaporizer while it is in use.
7.
IF YOUR VAPORIZER FAILS TO STEAM AFTER 10-15
MINUTES YOU MAY HAVE LOW MINERAL CONTENT
IN YOUR WATER. For areas where tap water has
low to moderate mineral content ADD SALT. For tap
water of low to moderate mineral content, ADD 1 TO
2 PINCHES (1/8 teaspoon) of ordinary table salt to the
water and mix thoroughly. After 10 minutes if your
vaporizer still does not produce steam add another
pinch or 2 of salt. Salt has no effect on the purity of
the steam or medication.
CAUTION: TOO MUCH SALT CAN CAUSE EXCESSIVE BOILING OR
BLOWN FUSE.
NOTE: Please do not add salt to your vaporizer each time you operate the
product. Salt will build up over time and you may not need to repeat
the process. Before adding salt operate your vaporizer following
steps 1-4. If vaporizer does not produce steam after 15 minutes
gradually add salt following the above directions.
8.
USE FRESH WATER AND MEDICATION each time vaporizer is used.
9.
AFTER EACH USE. Once the vaporizer has been allowed to cool, empty
any unused water from the water container. Shake the container gently
back and forth to remove any remaining water. Rinse the container
thoroughly, drain and wipe with a dry, clean cloth.
NOTE: All medicinal ingredients in Vicks
leaving only the mineral oil base in medication cup. This should be
emptied and cleaned with a piece of cotton.
IMPORTANT: To maintain proper operation of your vaporizer, be sure to follow
the Care and Cleaning instructions.
Special Notes
Discoloration/Black Particles
After use, the water residue in the bottom of the container may contain black
particles, and in some areas the water in the bottom of the container may
discolor. These conditions are normal and do not affect the purity of the steam
or medication. The container is easily cleaned with soap and water. Thoroughly
rinse and dry the container after cleaning.
Ventilation
When the vaporizer is used in closed or small rooms, check periodically for
proper ventilation, as excessive humidity can cause condensation stains
on walls.
Do not lift or move the
VapoSteam
are released in use,
®
®
7
Publicidad
