HON END BOOK SHELF Instrucciones De Montaje página 3

Illustration 6
Arrow
Left end
panel
Minifix
cam
Right end
panel
Illustration 7A
Minifix bolt
Shoulder
Dowel
Illustration 7B
Minifix bolt
Shoulder
2420956500_E
www.hon.com
END BOOK SHELF
Minifix
cam
Shelf
Minifix
bolt
Brace
panel
Minifix
bolt
Brace
panel
Dowel
6. Refer to Illustration 6. With arrows facing left end panel,
install four minifix cams (from hardware pack) into
holes along side edge of end panel.
Use the Phillips screwdriver to tighten minifix cams.
Turn minifix cams clockwise to tighten.
With arrows facing end panel, install two minifix cams
(from hardware pack) into holes along side edge of
each shelf.
Use the Phillips screwdriver to tighten minifix cams.
Turn minifix cams clockwise to tighten.
7. Refer to Illustration 7A for right handed units and 7B
for left handed units. Lay brace panel, with holes up on
cardboard or carpeted surface.
Use a rubber mallet to install five dowels (from hard-
ware pack) onto brace panel as shown.
Use the Phillips screwdriver to install seven minifix
bolts (from hardware pack) onto brace panel as shown.
Tighten each minifix bolt until bolt shoulder is flush
against surface of brace panel.
RH
LH
3 OF 7