Publicidad
Idiomas disponibles
Idiomas disponibles
A
A
Replacement of hoes
The hoes must be replaced by resting the machine on its side so that the hoes are parallel to the ground.
The hoes are very important because from their lenght the depth of burying the stones.
This is the reason why the hoes must be always efficient.
We also recommend to replace the entire set of nuts and bolts each time the screws are worn (NOTE: always use
the original, fine-pitch steel nuts and bolts).
After use
If the STONEBURIER Mod. TST is to remain unused for a long period, it is necessary to carry out following
instruction:
1. Thotoughly wash and dry the STONEBURIER Mod. TST.
2. Thotoughly check the working of the moving parts, replacing any damaged, worn or dateriorated parts.
3. Check the tightening of the bolts.
4. Preotect and lubricate all unpainted parts, cover the tool and keep it in a dry place so that it will ready for use
at any time.
Attention: before using it again, refer to the "Maintenance" chapter.
Guarantee
Our equipment is covered by guarantee against manufacturing and/or assembly defects for 1 year from the date
of delivery to the customer.
This guarantee is limited to the replacement of defective parts and does not include labour costs or transport.
This guarantee does not cover the following cases:
-
Where the user has made adaptations to the original structure.
-
Where the machine has been used in excess of its power limits.
-
Where R2 parts are not used.
-
Where the equipment is not used in accordance with the instructions in the manual.
-
Where the equipment has been used incorrectly.
The R2 Company reserves the right to modify the data in this manual whenever this is considered necessary for
technical or commercial improvements regardind the product itself.
B
g.4
g.6
g.5
A
g7
A
11
Publicidad
