Kunft KTB5023 Manual De Instrucciones página 6

2. OPERATING INSTRUCTIONS
2.1. Product Description
Jar cover
Spout
Jar
Motor unit
Switch
Base
Foot
2.2. Product usage
First Use
1. Unpack the appliance and place all parts on a horizontal surface.
2. Immerse the jar and jar cover in warm, soapy water, rinse them
and dry. Never immerse the motor unit in water to clean it to
prevent the risk of electric shock.
Caution: the blade is very sharp, handle with great care.
3. The correct assembly way will be described in detail in below
sections.
Before assembling the jar, be sure the power cord is unplugged
from the power outlet and the switch is on the 0 position.
The jar is suitable for mixtures where juice and pulp are mixed.
To attach the jar, place it into motor unit directly in place.
Note: Make sure the Jar is assembled into the motor unit properly,
there is interlock switch on the position, if the Jar is not assembled
properly, the blender will not operate.
Measure cup
Handle
10
table blender
Blending fruit
and vegetable:
1. Before attaching the power cord into
the outlet, make sure the switch is in
the 0 position.
2. Peel or core the fruit or vegetables
and then cut it into small dices. Put
the food pieces into the jar. Usually,
certain amount of purified water has
to be added to facilitate the smooth
running of the appliance. The pro-
portion of food to water is 2:3. The
amount of the mixture should not ex-
ceed the max level as indicated on
the jar.
Note: never use boiling liquids or run
the appliance empty. The jar can be
used to crush ice.
3. Place the jar cover on the jar. Turn the jar cover into the jar to lock
it in place.
4. Turn the switch to the desired setting - there are three setting: P, 0,
1, 2. Turn the switch to 'P' position and hold it to pulse for delicate
chopping. Release it to return to 0 position.
5. The consecutive operation time shall not exceed 3 minutes. A
minimum of 1 minute rest is required between two consecutive
cycles.
6. Turn the switch to 0 position once the mixture has been blended to
your desired consistency.
7. Remove the jar from the motor unit (remove it by pulling upwards),
carefully remove the jar cover, pour and serve.
2.3. Maintenance
The "Auto Clean" feature can clean the blender and blade assembly
easily, rapidly in complete safety.
1. Pour some warm soapy water into the jar and turn the switch to P
position for a few seconds.
2. Remove the jar from the motor unit by directly taking it upwards
and rinse the jar and jar cover under running water.
3. Wipe the outer surface of the motor unit with a damp cloth. Do
not use abrasive cleansers. Never immerse in water for cleaning.
4. Dry all parts and then reattach them.
EN
KTB5023
11