Publicidad
Idiomas disponibles
Idiomas disponibles
6. The generating set may be normally loaded.
WARNING
Connect the output terminal of the generating set with
the electric equipment. Don't start or stop the engine
when the electric equipment is in "ON" status.
VFT meter (If applicable)
The VFT meter can be used for displaying voltage,
frequency(hertz), run time, and total run time as
applicable.
(Display mode depends on the configuration). The
LCD displays each mode by pressing the button below
the display.
The display meter sets as either automatic switching
mode or manual operation mode. In the manual
state, press MODE BUTTON for mode switching; But
in automatic mode, MODE BUTTON is used for reset
(operate cautiously when necessary).
1. Voltage (U):
Output voltage of the generator.
2. Frequency (F):
Output frequency in hertz.
www.ducsonpower.com
3. Run time (R):
Run time of the generator for the current session.
Note: If display value is less than 100,the numeric
display will accurate to one decimal place. If the
operation time is 100 hour or greater, the display will
be "401","102" and so on.
4. Total run time:
Total
run
time
of
operation.(display
mode
configuration)
(1) The display value is accurate to one decimal place;
or
(2) The display value shows as a integer.
the
generator
since
depends
on
9
first
the
Publicidad
