Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
B
Before performing any cleaning or maintenance,
disconnect the unit from the power supply.
Never touch the moving blades.
Wear protective gloves!
Maintain this product regularly and carefully! If the
product is improperly maintained, it may fail at its
intended task, which may produce fatal consequences.
WARNING:
Wear protective clothing and observe all safety
instructions to prevent serious personal injury.
A
1. Keep the product clean. Remove debris from it after
each use and before storage.
, costillas realzadas)
2. Regular and proper cleaning will help ensure safe
use and prolong the life of the product.
3. Inspect the product before each use for worn and
damaged parts. Do not operate it if you find broken
and worn parts.
WARNING:
Only perform repairs and maintenance work according
D
to these instructions! All further works must be
performed by a qualified specialist!
LUBRICATING THE BLADE
WARNING:
Always allow the blades of the hedge trimmer to come
Fig. 6
B
to a stop and remove and disconnect the unit from the
power supply before lubricating. Failure to do so could
result in accidental starting causing possible serious
personal injury.
(gâchette,
gatillo
For easier operation and longer blade life, lubricate the
hedge trimmer blade before and after each use.
Lay the hedge trimmer on a flat surface. Apply light
weight machine oil along the edge of the top blade.
NOTE: If you will be using the hedge trimmer for
an extended time, it is advisable to oil the blade
periodically.
verrouillage,
gatillo
del
1. Stop the hedge trimmer.
Fig. 7
2. Disconnect the unit from the power supply. Lubricate
the hedge trimmer as described above (Fig.3).
WWW.SENIXTOOLS.COM
MAINTENANCE
D
Fig. 6
C
del
Fig. 7
iii
Fig. 8
C
Fig. 9
Fig. 8
SHARPENING THE BLADE
Allow the blades of the hedge trimmer to come to a stop
A
in the position shown. This will allow clearance for the
file between the cutter teeth and the guard teeth.
Disconnect the unit from the power supply.
Clamp the blade assembly in a vise and file the
exposed cutting surface of each blade tooth with an 8
in. smooth round file, 1/4 in. or 7/32 in. in diameter. Be
sure to retain the original angle of the tooth when filing.
Remove the hedge trimmer from the vise, and restart
the hedge trimmer. Allow the blades of the hedge
trimmer to come to a stop so that the unsharpened
edges on the other side of the cutter blade teeth are
exposed (Fig.4).
Fig. 9
A
A - Cutting teeth (dents de coupe, dientes de
corte)
B - Guard teeth (dents de coupe, dientes de
proteción)
Fig. 10
A - Cutting
corte)
B - Guard
proteción)
Fig. 10
A - Blade cover (fourreau de lame, cubierta de la
hoja)
A - Blade cover (fourreau de lame, cubierta de la
Fig. 3
B
B
A
A - Cutting teeth
teeth
(dents
de
B - Guard teeth
teeth
(dents
de
coupe,
Fig. 4
A
coupe,
dientes
de
dientes
de
13
Publicidad
