Senix HTE3.8-L Manual Del Operador página 15

PROBLEM
Product does not start
Product does not reach full power
Result is unsatisfactory
Vibration or noise is excessive
If further assistance is required, take the unit to a qualified service dealer.
WWW.SENIXTOOLS.COM
TROUBLESHOOTING
POSSIBLE CAUSE
Extension cord not connected to the
power plug
Extension cord not connected to
power source
The safety button or the trigger
switch is not fully engaged
Air vents are blocked
Cutting attachment is worn
Blades or blade support bent
Bolts/nuts are loose
SOLUTION
Check extension cord is fully
connected to tool
Check extension cord is fully
connected to a live receptacle
Refer to chapter "SWITCHING ON
AND OFF"
Clean the air vents
Replace with a new one
Straighten blade or blade support
Tighten bolts/nuts
15