Echelon STRIDE 5s Manual De Instrucciones página 23

While one person holds the console
up close to the top of the uprights,
the other person should connect
the matching wires f rom the right
upright to the right side of console.
BE CAREFUL TO NOT CLIP WIRES!
Insert console completely into
uprights.
Once connected, push wires
carefully back into upright.
2
1
Make sure holes are aligned, insert M10 bolt with M10 spring washer and
M10 flat washer. Tighten bolts with 6mm Allen Wrench. Repeat for left and
right uprights.
BE CAREFUL TO NOT CLIP WIRES!
Insert console halfway into the
uprights. Before inserting completely,
make sure to pull the top wire on both
left and right sides f rom the console
through the top hole of the upright.
4
3
23
2