ToughTested TT-PB-PD30 Manual Del Usuario página 4

CHARGING THE POWER PACK
04
Charging the Power Pack
• Connect either of the included USB cables to a USB power source.
• The LED indicators will light in sequence to indicate charging. When all 4 LEDs are lit the powerbank
is fully charged.
• The LEDs will turn off 30 seconds after the powerbank is fully charged
* Using the C to C cable with a USB PD charger of 45W or higher will allow for the fastest recharge time.
Recharging times using different power adapters:
Micro USB 1A input 37 hrs
Micro USB 2A input 19 hrs
Micro USB QC2/QC3 input 9 hrs
USB-C 3A input 12.5 hrs
USB-C PD 45W input 4 hrs
Charging your devices
This Power Pack can charge all your USB devices. With 4 output ports you can even charge all at the same
time. This Power Pack supports devices with QC2/QC3 and PD Power Delivery fast charging built-in as well as
devices that use standard USB charging.
USB-C laptops must use the USB-C to C cable for charging.
To check the power level of the Power Pack press the power button:
• 1st LED indicator lit - up to 25% capacity remaining
• 1st and 2nd LED indicators lit - up to 50% capacity remaining
• 1st, 2nd, 3rd LED indicators lit - up to 75% capacity remaining
• All 4 LED indicators lit - between 75% and 100% capacity remaining
For best results fully recharge before first use
Using the included charge cables, connect your device to one of the output ports.
If your device is equipped with USB PD technology connect using the USB-C to C cable for fastest charging.
If your device is equipped with QC2/QC3 technology use the USB A to C cable and connect to the QC3 USB port.
Using a fast charge port with a device that does not support fast charge technology will not damage the device,
it will just charge at standard speed.
CHARGING YOUR DEVICES
05