Emerio HM-126681 Manual De Instrucciones página 5

HM-126681
PARTS DESCRIPTION
1. Eject button
2. Speed control
3. Handle
4. Beaters
5. Indicator lights
6. USB port
7. USB cable
BEFORE FIRST USE
1. Carefully unpack the hand mixer and remove all packaging material.
2. Clean the beaters in warm water, rinse and dry thoroughly before use.
HOW TO CHARGE
1. The appliance cannot be charged when the speed control in on setting 1, 2 or 3. Make sure the speed
control is set to 0.
2. Connect the USB cable to the USB port on the appliance. The appliance can be charged by using USB power
supply (DC 5V, 2A).
3. Indicator lights will flash while charging and will stop once the unit is fully charged. See section "INDICATOR
LIGHTS" for details.
Note: the unit is shipped with approx. 30% charge in the batteries. One or two indicator lights will illuminate
during use. The unit will operate properly without charging. It is recommended to fully charge before first
use for the best performance.
4. It will take approx. 5 hours to fully charge the unit.
TO ATTACH THE BEATERS
Be sure the speed control is in the off position 0. Insert the beaters into the appliance by aligning the tabs on
the beaters with the slots in the motor housing. Push firmly until the beaters lock in place. Beaters can be
inserted into either slot.
TO REMOVE THE BEATERS
Slide the speed control to the off position 0. While pressing the eject button, pull out the beaters.
Note: do not eject the beaters during operation. Slide the speed control to 0 and then eject the beaters.
CAUTION: The appliance will operate if the speed control is pushed forward. Make sure to keep fingers off the
speed control while ejecting the beaters.
HOW TO USE
1. After attaching the beaters to the appliance, place the beaters directly into the container holding
ingredients to be blended.
2. There are three speed settings: 1, 2 and 3, with 1 being the lowest speed setting. Slide the speed control
forward to level 1 speed setting.
To increase the speed, continue to slide the speed control forward to level 2 or the highest speed level of
3.
3. Do not use the appliance for longer than 3 minutes at a time. After 3 minutes of continuous use, the unit
will automatically shut off. The unit can be operated again after a 5-minute rest cycle. Slide the speed
control to 0 and allow the unit to cool.
- 4 -
EN