COMPLETE INSTALLATION
Check electrical requirements. Be sure that you have the
■
correct electrical supply and the recommended earthing
method.
INSTALLING COIN SLIDE AND COIN BOX
The coin slide mechanism, service door lock and key, and coin
box lock and key are not included with some models but can
be obtained from the usual industry sources. The coin slide
(W10813856) supplied by Greenwald was used for testing and
evaluation purposes. If a different supplier is used, ensure that
the switch is D41 or a similarly qualified switch construction.
Alternative constructions require review by
a Whirlpool codes engineer.
Remove the service door of the
meter case by lifting it up at the
back. Install the money-accepting
device. (Refer to manufacturer's
instructions for proper installation.)
Extra wire should be coiled and
tie-wrapped to the mounting hole
inside the meter case.
An earthing connection is needed
for the coin slide, which can be
made by connecting the available
harness (W10846503) to the coin
slide. The provided earthing clip is
designed for 0.89–1.27 mm material
thickness.
Check that all parts are now installed. If there is an extra part,
■
go back through steps to see what was skipped.
Check that you have all of your tools.
■
Check that shipping materials were completely removed
■
from washer.
Dispose of/recycle all packaging materials.
■
Check that the water faucets are on.
■
Check for leaks around faucets and inlet hoses.
■
Remove film from console and any tape remaining on
■
washer.
Plug into an earthed outlet or connect power.
■
Check that circuit breaker is not tripped or fuse is not blown.
■
Start washer using the payment system (if available) to
■
check that the wash cycle completes without an error code
or water leak.
Install a lock and cam on the meter case service door. Install
the coin vault with lock and key in the meter case opening.
For Free Vend, an OPL kit can be purchased from Whirlpool.
Whirlpool part number W10222023.
Earthing
Earthing
connection
connection
17