Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING AND ADJUSTMENT
WARNING-Max Temp=180°C -Th is luminaire is not suitable for mounting on flammable surfaces.
The luminai re is supplied with a yoke with a 12.7mm diameter hole allowing the luminaire to be fitted
with a hook clamps in order that it can be mounted on a 5cm tube. Using the "T" bar on the side, the
tilt angle can be adjusted.
LAMP TYPES
Standard lamp types are shown in the box below.
Type
DWE PAR36
N.B. Always use bulbs of identical Voltage and
Wattage in the same circuit.
Operating instruction
You have only one mode to operate this luminaire.
DMX Mode
DMX mode allows you link a serial unite into a chain
with DMX linking cable-stereo cable with 3-pin
XLR-plug and connector. Then you can control them with a
standard DMX. When you set the dip10 to "OFF", they will
step into DMX mode, this unit have two DMX channels,
channel1 control the left two lamps brightness, and channel2
control the right two lamps brightness. Dip 1~9 set the DMX
address. Adjust the brightness of them via adjusting the
DMX value. The brightness is increased when the DMX value
increasing
is
BLINDER 436 L DMX
Voltage
Wattage
120v
650w
User Manual/Manual de uso
DMX Address
This symbol on the product or on its packaging indicates that this product
shall not be trated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical an electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling
of this product. The recycling of amterials will help to conserve natural
resources. For more detailed information sabout recycling of this product,
please contact your local city office, your household waste disposal service
or the shop where you purchased the product.
Pag 2
Publicidad
