Mark BLINDER 436 L DMX Manual De Uso

BLINDER 436 L DMX
Instructions
BEFORE OPERATING THIS DEVICE,
READ, UNDERSTAND AND FOLLOW
THESE INSTRUCTIONS. BE SURE TO
SAVE THIS MANUAL FOR FUTURE
REFERENCE.
WARNING -This luminaire is intended for
professional use only and doe s not compl y
with certain domestic lighting regulations.
IMPORTANT NOTES
˙Min imum distance from a lighted object is 1Meter.
˙Ma ximum rated ambient temperature is 45°C.
˙Input cabl e may be subjected to temperatures up to 180°C.
˙Ma ximum rated voltage is 240V.
˙Normal frequency is 50/60 H z.
˙Ma ximum rated wattage is 650 Watts per lamp.
SAFETY NOTES
˙Replace l amp if cracked or thermally deformed.
˙The Spot Banks should not be used in explosive or inflammable
environments.
˙Always fit safety wire from luminaire to supporting framework.
˙Do not over voltage luminaire.
˙ Whe n connecting to the electrical supply, ensure that the luminaire is effectively earthed, that the
supply is at the rated voltage for the lamp, wiring is complete and as shown on the diagram below
and that the correct polarity is observed.
˙ ˙ If the exte ˙ rnal flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by
the manufacturer or his service agentor a s imilar qualified person in order to avoid a hazard.
˙Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to filch
an extent that their effectiveness is impaired, for example by cracks or deep screeches.
˙Always disconnect from the mains, when the device is not in user or
before cleaning it.
ELECTRICAL CONNECTION
WARNING -Thi s appliance MUST be earthed.
The supply cables should be connected to an approved plug in accordance
with following code:
Wire Colour
Green & Yellow
Blue
Bro wn
LAMP REPLACEMENT (see Fig 1.)
1) Disconnect the luminaire from the power supply and allow cooling.
2) Undo the 2 screws that hold each lamp-retaining ring that holds the Par lamp.
3) Remove wires from the lamp by unscrewing the screw terminals.
4) To refit lamp, follow steps 1 to 3 in reverse order.
5) Ensure the lamp is seated properly and make sure no wires are trapped before refixing.
BLINDER 436 L DMX
Conne ction Plug Terminal Marking or Colour
Earth
Neutral
Liv e
User Manual/Manual de uso
LAMP RETAINING
SCREW
LAMP
TERMINAL
E Green & Yellow or
N Black
L Red
YOKE
BLINDER 436 DMX
Pag 1