Emerio SI-110298.4 Manual De Instrucciones página 6

SI-110298.4
PARTS IDENTIFICATION
1. Temperature regulator
2. Burst of steam button
3. Spray button
4. Spray nozzle
5. Water inlet cover
6. Indicator light
7. Steam control knob
8. Soleplate
9. Water tank
BEFORE INITIAL USAGE
Remove all packaging material. Make sure the appliance is unplugged and the temperature regulator is set at
position "OFF".
Open the water inlet cover and fill water into the opening up to the max level marked on the water tank. For
this, use the measuring cup. Do not use chemically de-calcified water.
Insert the power plug into a designated outlet and set the temperature regulator on the highest temperature
setting. After the indicator light goes off, set the steam control knob to your desired position and iron on an
old piece of cloth to remove possible residue.
With first use, there can be slight odour or smoke, but this is harmless and only of short duration. Make sure
there is adequate ventilation.
OPERATION
Before selecting the temperature, read the instruction manual for the iron or the care advice on the tag of the
clothing.
Note: If there is no care advice on the piece of clothing, then you should begin ironing with the lowest
temperature. With lower temperature, there will be less steam.
OFF
●
●●
●●● MAX
DRY IRONING

Connect the iron to a suitable mains supply outlet.

Ensure that the steam control knob is in the position

Select the setting on the temperature regulator.

When the indicator light goes off, the required temperature is reached. The iron is ready for use.

To turn off the iron, turn the temperature regulator counter-clockwise to position "OFF", set the iron
upright, and pull out the power plug.
STEAM IRON
Fill the water tank, as described before initial usage.
Steam ironing can be used in the temperature ranges ●, ●●, ●●● MAX. For the reliable functioning of the
steam ironing, the water tank must be at least 1/4 filled.
Nylon
Silk, wool
Linen, cotton, highest temperature
.
- 5 -
EN