Descargar Imprimir esta página

PIONEER DJ XPRS2 Serie Guia De Inicio Rapido página 3

Altavoz activo

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
Rear panel
(subwoofer model)
4
3
1
1 AC INPUT
The AC connection is established via the IEC connector. The IEC
connector is compatible with a lockout power cord (not included).
2 POWER
AC switch for turning the power on or off. When POWER is turned on,
the LED lights up.
3 LINK
The XLR output sends mixed input signals to other speakers or
subwoofers. VOLUME (input level) controls the level of signal sent to
LINK. The MASTER VOL and DSP control settings do not affect the
LINK signal.
4 INPUT LEFT (mono)/RIGHT
5 POWER indicators
The POWER LED lights up when the speaker is turned on.
6 SIG/LIMITER signal light
Lights up green when there is a signal, and red when the amplifier starts
to compress.
7 3DSP PRESET MODES
BOOST/EXTENDED LF/NORMAL
8 LPF
80 Hz/100 Hz/120 Hz
9 POLARITY
REVERSE/NORMAL
a VOLUME
Level control of an input signal.
Installation and connections
Important notes on installation
The sound produced by the speaker is subtly influenced by the conditions
of the room you use it in. Carefully consider the installation location before
setting up the speaker to ensure the best possible conditions.
7
AlphaTheta Corporation will not be liable for any damages arising from use
6
of the speaker (including but not limited to loss of business opportunities),
5
regardless of the installation method used.
Be sure to use the handles on the top or the sides of the speaker when
a
moving and installing it.
8
9
To help proper cooling, please make sure enough space is kept between
each speaker and nearby walls or other components (minimum 30 cm
or more above, behind, and to the sides of each speaker). Leaving
insufficient space may cause the temperature inside the speaker to rise,
leading to malfunction or permanent damage.
Installation using a speaker pole
XPRS102/XPRS122
The full-range models of the XPRS2 Series have a 35-mm-diameter pole
socket on the bottom surface.
The subwoofer model of the XPRS2 Series have a 35-mm-diameter pole
socket on the top surface in which the pole can be secured firmly.
The combinations shown in the following diagrams are recommended for
the XPRS2 Series. Using a different combination may result in the speakers
toppling over and possibly causing damage or injury. To use a speaker pole,
check the cautions below and perform the installation safely.
• At least two people should lift each speaker together to install it. Be sure
to give enough consideration to safety when performing the work.
• Use a 35-mm-diameter speaker pole. Use a commercially-available
product with a length of 900 mm or less. AlphaTheta Corporation will not
be liable for any damages (including but not limited to loss of business
opportunities) arising from the use of a speaker pole other than the type
specified.
• Install the subwoofer in a stable location and secure the speaker pole
firmly.
• Ensure there is no danger of speakers toppling over.
• Cables should be taped or tied together with suitable tape or cable ties
to avoid the danger of tripping on the cables and causing the speakers to
topple over.
2
Pole socket
Installation using a speaker pole
CAUTION
CAUTION
Front
35-mm-diameter
pole socket
Pole socket
XPRS102, XPRS122
XPRS1152S, XPRS1182S
En
3

Publicidad

loading

Este manual también es adecuado para:

Xprs102Xprs122Xprs1152sXprs1182s