Epomaker TH21 Guia De Inicio Rapido página 3

Q U I C K S T A R T G U I D E
B A S I C F U N C T I O N
Short Press to Switch to BT1;
FN + 1
Long Press to Pair Devices
Short Press to Switch to BT2;
FN + 2
Long Press to Pair Devices
Short Press to Switch to BT3
FN + 3
Long Press to Pair Devices
Short Press to Switch to 2.4G Mode;
FN + 4
Long Press to Pair Devices
Wired Mode
FN + 5
Toggle RGB Effects
FN + 6
Toggle RGB Colors
FN + 7
Calculator
FN + 8
P A I R I N G B L U E T O O T H
1. Hold Fn+1/2/3 for 3-5 seconds till the indicators flashes fast, the numpad is ready to pair.
2. Turn on your Bluetooth device and find"TH21 BT5.0" or "TH21 BT3.0", then connect. When the
keyboard is connected to the Bluetooth device, the light on the 1/2/3 key stops flashing and the
connection is done.
3. Press Fn+1/2/3 to toggle between the Bluetooth devices 1/2/3.
P A I R I N G W I R E L E S S 2 . 4 G H z
1. Hold Fn+4 for for 3-5 seconds till the light flashes fast, the keyboard is ready to pair.
2. Insert the 2.4G dongle to your device, the 4 key stops flashing green and the connection is done.
W I R E D M O D E
Toggle the switch to the wired mode, press Fn+5 till the T key lights up, and the keyboard enters
to the wired mode successfully.
T I P S O N C H A R G I N G
The Tab light is the battery indicator. When the numpad is at low battery, it flashes red; when the
numpad is charging, the Tab key remains red light; when the numpad is fully charged, the indicator
light is off.
T EC H N I C A L ASS I STA N C E
For technical assistance, please email to support@epomaker.com with your purchase order number
and a detailed description of your issue.
We normally respond to enquiries within 24 hours. If you purchased your keyboard from a distributor or
not from any official store of Epomaker, please contact them directly for any additional help.
Backlights Brightness
FN + -
Backlights Brightness +
FN + +
Battery Check
FN + .
Backlights Speed-
FN + ÷
Backlights Speed+
FN + ×
Battery Saving Mode
FN + Back
Fn+ Enter
Turn on/off Numpad
(Long press 3s in
wireless mode)
Fn+ Esc
Reset the numpad
(Long press 3s)
EN