TMC Optical Auto Top Up Instrucciones página 9

7. Ensure that all connections have been made correctly and securely Please Note: failure to do
so could result in operating problems and water overflowing from your sump or aquarium.
8. Connect PSU to mains and switch on.
Please Note: We strongly recommend that you regularly check the water parameters of your
aquarium to ensure optimum water quality.
1. Determine your ideal water level within your aquarium or sump.
2. Place the sensor in a suitable position in the aquarium or sump.
3. Ensure all connections are secure.
4. Check on a daily basis to ensure the sump or freshwater container is not running low on
water and top up as required.
5. Maintain regularly for continued, reliable operation.
6. When carrying out aquarium maintenance or acclimating animals in the aquarium, unplug
the Optical Auto Top Up sensor to prevent any unwanted activation due to an altered
aquarium/sump water level.
7. On a weekly basis (or more often in set-ups with high detritus levels or a refugium) ensure
that the sensor and anti-siphon valve are clean and free from any algae/bacteria growth or
detritus build up.
Please Note: The larger the surface area of the chamber or aquarium the Optical Auto Top
Up system is installed in, a higher volume will be evaporated before the switch will be acti-
vated. Ideally place the Optical Auto Top Up system in the return pump chamber of a sump.
Caution: To avoid possible electric shock, special care should be taken when using any
electrical appliance near water.
Caution: Always isolate the Optical Auto Top Up system from the mains electricity before
installing or carrying out any maintenance.
1. Check regularly to ensure that the Optical Auto Top Up sensor, anti-siphon valve and pump
are clean and free of any dirt or detritus, salt and/or calcium deposits.
Please note: We highly recommend that this is checked at least once a week. Failure to do
so could result in operating problems and water overflowing from your sump or aquarium.
2. Regularly check to ensure all connections are tightly secured.
3. Test Optical Auto Top Up sensor by physically moving it in the water to ensure switch is
operating correctly.
GENERAL OPERATION
MAINTENANCE
9