Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Install the unit in hard & flat floor, keep the room ventilated. Leave at least 20cm space around the unit
(when the water pipe is not connected).
1. Insert the water
pipe into the drain hole on the rear panel.
2. Connect the water pipe to bathroom, outdoor or a container, such as bucket.
NOTE:
1. Do not block the drainage port or water pipe.
2. Do not fold the water pipe or make it 1.5m higher than the bottom of unit.
3. Do not replace the rubber adaptor of the water pipe, it's the special accessory for the unit only, another
adaptor may not fit the unit. If it's damaged or lost, please call the customer service for replacement.
PARTS
Front
-31-
Publicidad
