Audio Pro Blue Diamond v.2 Manual De Instrucciones página 7

INSTRUCTIONS
Congratulations to your choise of Audio Pro Blue Diamond v.2 and to a new sound
experience.
Audio Pro Blue Diamond v.2 is a unique product built with advanced technology. It is very easy
to handle and install. Blue Diamond v.2 is equipped with the unique Audio Pro ace-bass technique
that in combination with the built-in 175 watts amplifier, the long throw 10" woofer and the extremely
solid cabinet offers a natural and deep bass reproduction at sound levels you never thought existed.
The Audio Pro Blue Diamond v.2 offers extraordinary performance and lots of possibilities. In
order to get the most out of your new loudspeaker, we recommend you to spend time and carefully
read these instructions before you connect and start up your system.
What is ace-bass ?
Normally, speaker design is bound to follow the laws of physics. The consequence will be, to
get deep bass, the speakerbox must be very large. With the ace-bass technique we can "change"
the laws of physics in the way that the driver believes it is placed in a much larger speaker box.
Furthermore, the ace-bass technology improves the driver performance. With the ace-bass
technique, we can design smaller subwoofers with deeper and cleaner bass.
1. UNPACKING
Carefully unpack the Audio Pro Blue Diamond v.2 and
check for any damages. If possible, keep the cartonbox if
future transportation would be needed. Locate the
enclosed accessories: 1 x RCA cord and 1 x Y-adaptor.
You should immediately contact your dealer if the spea-
ker is damaged .
2. CONNECTION
TWO CHANNEL ( Stereo).
Connect a good quality speakerwire between your amplifier
speaker output to HI LEVEL IN on the speaker amplifier.
Check carefully the phase (+ to +) and (- to-).
Caution: Do not connect the mains cord until all other
connections are completed.
Note: The signal is passed through the subwoofer amplifier
to the top crossover network. Adjust the subwoofer level
to match the upper speakers by using the Master level
control (2).
MULTICHANNEL (5.1 surround)
Connect your speaker as above (for two channel). In
addition connect the RCA cord from SUB-OUT on your
5.1 amplifier to LINE-IN on the speaker amplifier. Use the
Y-adaptor to connect both Left and Right subwoofer.
Caution: Do not connect the mains cord until all other
connections are completed.
Note: The speaker is working in the same way as for the
two channel connection (above). However, the separate
subwoofer channel (5.1) is also handled by the subwoofer.
Use the LINE-IN LEVEL to adjust the 5.1 subwoofer level
(1).
7