PLAYKIN QUAD RACER Manual De Instrucciones página 36

ASSEMBLY
ATTENTION
×
Assembly must be carried out by an adult. Keep children away, the product contains
small parts that can cause suffocation, pay special attention to protective materials
and packing bags.
×
Make sure that the power switch is set to "OFF" before assembling the equipment.
−
Before first use, charge the battery for at least 18 hours.
FRONT AXLE INSTALLATION
1. According to the figure, align the hole
that rotates to connect the iron sheet,
and then tighten and fix it with the
bolt and nut.
INSTALLING THE REAR WHEEL
washer
1. Install the rear axle joint from the left side of the car body, then install the joint, tube, wheel,
gasket and nut. Install the drive motor, rear wheel and nut on the right side of the car. Finally,
tighten the two nuts with a spanner spanner.
INSTALLING THE FRONT WHEEL
washer
1. Install the front wheel, place the gasket on the front axle of the steering gear and install the
front wheel, washer and nut in turn. Finally, tighten both nuts with a spanner spanner.
wheel
rear axle
rear axle
wheel
Spanner
driving motor
36
nut
Spanner
Spanner
nut