Ryobi RY120350 Manual Del Operador página 9

CONNECTING THE SPRAY WAND TO THE
POWER CLEANER
See Figure 2.
Insert the end of the spray wand into the power cleaner

and rotate clockwise to secure.
Pull on the spray wand to be certain it is properly secured.

CONNECTING THE 3-IN-1 NOZZLE TO THE
SPRAY WAND
See Figure 3.
Align the arrows and insert the end of the 3-in-1 nozzle

into the spray wand and push it until it clicks into place.
Pull on the 3-in-1 nozzle to be certain it is properly secured.

To remove, press the button on the wand and pull to

remove the 3-in-1 nozzle.
CONNECTING THE SIPHON HOSE TO THE
POWER CLEANER
See Figure 4.
Completely uncoil and straighten the siphon hose to

prevent kinks.
Align the quick connect collar on the siphon hose to the

water inlet on the power cleaner.
Push the collar onto the water inlet until it clicks securely

into place.
Pull on the hose to be certain it is properly secured.

CONNECTING THE SIPHON HOSE TO A
GARDEN HOSE
See Figure 5.
The siphon hose can be submerged directly into any fresh
water source like a lake, pool, or a 5 gal. bucket for maximum
portability or attached to a garden hose as described below.
ASSEMBLY
NOTICE:
Always observe all local regulations when connecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drinking
water supply. Direct connection through a receiver tank
or backflow preventer is usually permitted.
NEVER use hot water. Before connecting a garden hose to
the power cleaner:
Run water through the hose for 30 seconds to clean any

debris from the hose.
To connect the garden hose to the siphon hose:
Completely uncoil the garden hose or remove completely

from reel to prevent kinks.
NOTE: There must be a minimum of 10 feet of unrestricted
hose between the power cleaner intake and the hose
faucet or shut off valve (such as a "Y" shut off connector).
Unscrew and remove the filter from the end of the siphon

hose. Store filter for later use.
With the hose faucet turned completely off, attach the

end of the garden hose to the siphon hose water intake.
Tighten by hand.
NOTICE:
Do not run the power cleaner without water supply con-
nected and turned on, as this may damage the high pres-
sure seals and decrease pump life. Completely unwind
the hose from its reel or coil and make sure the hose is not
being restricted by tires, rocks, or any other objects that
may lessen or prevent water flow to the power cleaner.
7 — English