Publicidad
Idiomas disponibles
Idiomas disponibles
SpeedTouch™ safety instructions
Directive
Unless expressly and unambiguously approved by Thomson multimedia, you may not:
• disassemble, de-compile, reverse engineer, trace or otherwise analyze the equipment, its content, operation, or functionality,
or otherwise attempt to derive source code (or the underlying ideas, algorithms, structure or organization) from the equipment
or from any other information provided by Thomson multimedia, except to the extent that this restriction is expressly
prohibited by local law;
• copy, rent, loan, re-sell, sublicense, or otherwise transfer or distribute the equipment to others;
• modify, adapt or create a derivative work of the equipment;
• remove from any copies of the equipment any product identification, copyright or other notices;
• disseminate performance information or analysis (including, without limitation, benchmarks) from any source relating to the equipment.
Such acts not expressly approved by Thomson multimedia will result in the loss of product warranty and will invalidate the user's
authority to operate this equipment.
Thomson multimedia disclaims all responsibility in the event of use that does not comply with the present instructions.
Trademarks
The following trademarks are used in this document:
• SpeedTouch is a trademark of Thomson multimedia.
• Microsoft, Windows, MS-DOS and Internet Explorer are either registered trademarks or trademarks of Microsoft Corporation.
• Apple and MacOS are registered trademarks of Apple Computer, Inc.
• Adobe, the Adobe logo and Acrobat Reader are trademarks of Adobe Systems, Inc.
• Netscape and Netscape Navigator are registered trademarks of Netscape Communications Corporation.
• Ethernet is a trademark of Xerox Corporation.
• UNIX is a registered trademark of UNIX System Laboratories, Inc.
Other products may be trademarks or registered trademarks of their respective manufacturers.
Safety instructions
Climatic conditions
This SpeedTouch product is intended for:
• In-house stationary desktop use; the maximum ambient temperature may not exceed 40°C (104°F).
• It must not be mounted in a location exposed to direct or excessive solar and/or heat radiation.
• It must not be exposed to heat trap conditions and must not be subjected to water or condensation.
• It must be installed in a Pollution Degree 2 environment.
Cleaning
Unplug this product from the wall socket and computer before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
10
Water and moisture
Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement or near
a swimming pool. Transition of the product from a cold environment to a hot one, may cause condensation on some of its internal
parts. Allow it to dry by itself before re-starting the product.
Electrical powering
The powering of the SpeedTouch product must adhere to the power specifications indicated on the marking labels. Modem rated
input: 9V d.c, 1000 mA. The power supply must be class II and a limited power source. It must be tested and approved to
national or local standards. The use of other types of power supplies is prohibited. If you are not sure of the type of power supply
needed, consult the product's user documentation or contact your local product dealer.
Power cord protection
Do not allow anything to rest on the power cord. Do not locate this product where the card will be subject to persons walking on it.
Pay particular attention to the cord's plug and the product's power entry point; do not use the product when these points of
the cord are damaged.
Overloading
Do not overload mains supply outlets and extension cords as this increases the risk of fire or electric shock.
Servicing
To reduce the risk of electric shock, do not disassemble this product. None of its internal parts are user-replaceable; therefore, there
is no reason to access the interior. Opening or removing covers may expose you to dangerous voltages. Incorrect reassembly could
cause electric shock if the appliance is subsequently used.
If service or repair work is required, take the product to a qualified service dealer.
Damage requiring service
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If liquid has been spilled into the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally.
• If the product has been dropped or damaged in any way.
• If the product exhibits a distinct change in performance.
Immediately disconnect the product if you notice it giving off a smell of burning or smoke. Under no circumstances must you open
the equipment yourself; you run the risk of electrocution.
Central splitter / distributed filter(s)
If telephone service is required on the same line, a central splitter or distributed filter(s) must be installed for optimal DSL performance.
Depending on you DSL configuration and type of splitter / filters, installation must be carried out by qualified service personnel.
Consult your telephone service company or DSL service provider for instructions.
11
Publicidad
