Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL
FRESCO
REF. 200093201B • 200093203B
REMOTE CONTROL CONNECTION
_____________________________________________________________________________
REMOTE RECEIVER INSTALLATION—IMPORTANT
_____________________________________________________________________________
1. Confirm that the main power source has been turned off prior
to installation.
POWER TABLE
_____________________________________________________________________________
INPUT VOLTAGE
FAN LOAD
200~240VAC/50Hz
RECEIVER
LIGHT LOAD
24V 40W
200W (max.)
REMOTE CONTROL
_____________________________________________________________________________
MINIMUM SPEED
MEDIUM SPEED
MAXIMUM SPEED
FAN ON/OFF
NOTICE
____________________________________________________________________________
1. When the control does not connect to the fan, check if the battery
switch contact is compliant, that the positive and negative poles are
correctly connected, and that the battery charge is sufficient. If the
battery voltage is too low, it will affect the transmission intensity and
may cause the remote control to fail. Please replace the battery in time.
2. When the control does not connect to the fan, please check if
there are similar products nearby. Simultaneous transmission of
radio waves by the same remote control products may interfere with
each other and may affect the reception effect.
3. Battery charge will decrease over time. Please replace the used
battery to avoid damage to the control and handle it correctly.
4. If not using the fan for a long period of time, please remove the
batteries from the control.
REVERSING SWITCH
[ EN ]
1H DELAY
2H DELAY
4H DELAY
LIGHT ON/OFF
11
Publicidad
